Aries-automotive 45-3012 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Aries-automotive 45-3012. Aries Automotive 45-3012 User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Washers and 1Omm lock washers (Figure 4). Do
Hex Bolts, (4) 1Omm Nuts, (8) 1Omm flat Brackets using the included (4) 1Omm x 3Omm
8 10mm Flat Washers
8 10mm Lock Washers
4 10mm Nuts
4 10mm x 30mm Hex Head Bolts
PART NUMBER 45-3012
2011 FORD SUPER DUTY 350-550
Page 1 of 2
PARTS LIST:
1 Bull Bar
1 Driver/Left side Mounting Bracket
1 Passenger/Right Mounting Bracket
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. NOTE: It may be necessary to remove/relocate front license plate and license plate bracket. It
is not required, but strongly recommended. If local/state law requires a license plate, license
plate relocation kit is available.
3. From front of vehicle remove the driver side bumper mount bolts (Figure 2).
WARNING! Do not remove passenger and driver bumper mount bolts at the same time.
Remove one side at a time.
4. Place Mounting Bracket onto vehicle and line it up against the outer gusset bend on the frame.
Leave about 1/8” clearance between bottom of Mounting Bracket and bumper. Secure
Mounting Bracket to vehicle using the factory bolts (Figure 3). Fully tighten these bolts at this
time.
5. Once the driver side Mounting Bracket is fully tightened, repeat steps 2 - 4 for passenger side
Mounting Bracket.
6. With help position Bull Bar on the outer side of Mounting Brackets. Attach Bull Bar to Mounting
not tighten at this time.
7. Level and adjust Bull Bar as desired, then tighten all hardware at this time.
8. Do periodic inspections to the installation to make sure that all hardware is secure and tight..
INSTALLATION INSTRUCTIONS
BIG HORN BULL BAR
Driver Side
Mounting Bracket
Passenger Side
Mounting Bracket
Figure 1
Vue de la page 0
1 2

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTIONS

Washers and 1Omm lock washers (Figure 4). Do Hex Bolts, (4) 1Omm Nuts, (8) 1Omm flat Brackets using the included (4) 1Omm x 3Omm 8 10mm Flat Was

Page 2 - Figure 5

10mm Nuts 10mm Lock wahers 10mm Flat Washers 10mm x 30mm Hex Bolts Page 2 of 2 Installation Complete

Commentaires sur ces manuels

Pas de commentaire